Table of Contents
Advertisement
7541-03x
8xx scanner error
codes
840.01
840.02
840.03
841.00
841.01
841.02
841.03
841.04
841.05
841.06
842.00
842.01
842.02
843.00
843.03
844.00
849.01
849.10
2-40
Service Manual
Description
The scanner has been
manually disabled
The scanner has
automatically been disabled
by the controller
Scanner cable unplugged
Invalid configuration or ASIC
not found.
Invalid AFE setting.
Delayed interrupt detected.
Failed indirect register test.
Failed external DRAM test.
Image pipe timeout
Scanner did not initiate scan.
No response
HW Protocol
Logical protocol
Carriage home
Pick roll failed to engage
Lamp failure
Machine has an installed
modem that should not be
present.
Machine has an installed
hard drive that should not be
present.
Action
Enter the configuration mode to re-
enable the scanner.
Enter the configuration mode to re-
enable the scanner.
Check the scanner cables for proper
connection to the scanner and RIP
board.
See
"841.00 Invalid configuration or
ASIC not found" on page
2-56.
See
"841.01 Invalid AFE setting" on
page
2-56.
See
"841.02 Delayed interrupt
detected" on page
2-57.
See
"841.03 Failed indirect register
test" on page
2-57.
See
"841.04 Failed external DRAM
test" on page
2-57.
See
"841.05 Image pipe time-out" on
page 2-57
See
"841.06 Scanner did not initiate
scan" on page 2-58
See
"842.00 No response / 842.01 HW
protocol / 842.02 Logical protocol" on
page
2-58.
See
"842.00 No response / 842.01 HW
protocol / 842.02 Logical protocol" on
page
2-58.
See
"842.00 No response / 842.01 HW
protocol / 842.02 Logical protocol" on
page
2-58.
See
"843.00 Carriage Home" on
page
2-59.
See
"843.03 Pick roll failed to engage"
on page
2-59.
"843.03 Pick roll failed to engage" on
page
2-59.
Uninstall the modem. See
"849.01
Device had modem installed, but
config ID indicates it should not" on
page
2-60.
Uninstall the hard drive. See
Device had HD installed, but config ID
indicates it should not" on page
"849.10
2-60.
Previous
Next
Go Back
Advertisement
Table of Contents
