Table of Contents
Advertisement
7541-03x
Option card service check
Step
Action and questions
1
Remove all the cards, and POR the machine. Does the
printer work normally?
2
Replace the RIP. Does the printer work normally?
3
Replace the cards, and POR the machine until the
error is replicated. Did the error replicate itself.
4
Check the ISP connector cable, connected to the failed
card for continuity. Is there continuity?
5
Replace the connector cable. Did this fix the problem?
6
Replace the ISP card that triggered the error when it
was added. Did this fix the issue.
7
Replace the RIP. Did this fix the issue?
Serial port
Run the
"Serial Wrap Test" on page
Note: The Serial Wrap Test is designed to check the serial port hardware by using a wrap plug, P/N
1329048, and invoking the Serial Post Diagnostic Test. The test helps isolate the printer from the serial
cable and host computer. The test provides failure information on the display for approximately three
seconds. If the test indicates a problem, replace the option card. If the problem continues, replace the RIP
board.
Flash options
Run a copy of the test page, and check to see if the option you are checking is listed. The printer does not
recognize the option being installed if the option is not listed. Be sure the memory card assembly is installed
correctly and is not broken or damaged. If the Memory card assembly is correctly installed, not broken or
damaged, then run the
problem continues, replace the RIP board.
DRAM options
This service check is the same as the flash memory option service check with the following exception: Run the
"DRAM Test" on page 3-21
broken or damaged. If the test fails, replace the DRAM card assembly. If the problem continues, replace the RIP
board.
2-94
Service Manual
3-22.
"Flash Test" on page
3-24. If the test fails, replace the Flash card assembly. If the
from the menu if the DRAM Memory card assembly is correctly installed and not
Yes
No
Go to step 3.
Go to step2.
Go to step 3.
Contact your
second level
support.
Go to step 4.
Problem solved
Go to step 6.
Go to step 5.
Problem solved
Go to step 6.
Problem solved
Go to step 7.
Problem solved
Contact your
second level
support.
Previous
Next
Go Back
Advertisement
Table of Contents
