Flatbed Assembly Removal - Lexmark X925 7541-03 series Service Manual

7541-03x

Flatbed assembly removal

1.
Remove the op panel assembly. See
on page 4-15.
2.
Remove the ADF assembly. See
3.
Remove the RIP cover. See
4.
Remove the rear cover.See
5.
Disconnect the flatbed cables (A) from the RIP.
6.
Using a short handle screw driver, remove the two screws (B) on the left underside of the flatbed platform.
7.
Using a short handle screw driver, remove the two screws (C) on the right underside of the flatbed
platform.
8.
Remove the flatbed from the scanner platform.
9.
Remove the flatbed front cover. See
Note: After installing the new flatbed, perform the scanner calibration procedures. See
page 4-211.
4-116
Service Manual
"Op panel top cover" on page 4-13
"ADF assembly removal" on page
"RIP cover" on page 4-5.
"Rear cover" on page 4-7.
"Flatbed front cover" on page
and "Op panel bottom cover"
4-113.
4-117.
"Adjustments" on
Previous
Next
Go Back