Table of Contents
Advertisement
Change history
Revision date
2014/11/14
2014/10/16
2014/08/11
2014/04/10
2014/04/8
2014/04/01
2013/12/16
2013/08/30
2013/07/01
2012/01/07
2012/10/23
2012/06/25
2011/12/14
2011/12/01
2011/11/22
2011/10/04
2011/08/25
Updates
Added the topic
"Flatbed scanner cables removal" on page
Updated
"Paper specifications" on page
Parts catalog assembly 3—Deleted part numbers 40X6973 and 40X6307, and replaced
them with 40X9241.
Changed the action for error code 953.xxx to 958.xxx in page 2-39 to "Replace the RIP
board. Replace the ICC PCBA if replacing the RIP board does not fix the problem."
Updated
"Color Alignment" on page
Added the service check
"843.03 Pick roll failed to engage" on page 2-59
Diagnostic information chapter.
Removed the Reset color calibration topic from the Diagnostic information chapter.
• Added "30K ADF separator roll and ADF pick roll maintenance kit" part number
(40X9227).
• Updated the following Configuration menu items:
- Reset Separator Roll and Pick Assembly Counter
- Reset Fuser Counter
- Reset Maintenance Counter
- Reset Transfer Belt Counter
Added Steps before starting the 9yy.xx service checks.
Added connector information for CN19 and CN20 under
connectors" on page
5-10.
Updated Imaging unit (photo developer) missing service check:
Step 5 and 6: 'Changed sub unit' to 'subframe'.
• Added
"Safety feature notice" on page
• Updated and changed the Abnormal fuser temperature error service check to
OFF switch automatically switching to the Off position service check" on
page
2-48.
Added an installation note in the
• Added a note in the
"Paper feed unit removal" on page
• Added the following removal procedures:
-
"Main tray paper guide removal" on page
-
"Multi-purpose feed tray paper guide removal" on page
• Updated the parts catalog art for
Updated the
"Printhead controller board / engine board replacement" on page
• Changed PN 40X6424 with PN 40X5984 for the
on page
7-27.
• Added Change history section
• Added the navigation buttons
Changed PN 40X6730 to 40X6370 for the
1-6.
3-14.
"Printhead controller
2-1.
"Waste toner sensor removal" on page
4-179.
"Paper feed" on page
7-24.
"220 V Low voltage power supply"
"RIP print controller cable" on page
7541-03x
4-162.
in the
"ON /
4-112.
4-68.
4-181.
4-2.
7-27.
xix
Preface
Previous
Next
Go Back
Advertisement
Table of Contents
