Adf Cover Open Service Check - Lexmark X925 7541-03 series Service Manual

ADF cover open service check

Step Questions / actions
1 Is the ADF cover properly closed
2 Close the ADF cover.
Does the problem go away?
3 Perform the ADF cover open sensor test.
See "SCANNER TESTS" on page
Does the sensor work properly.
4 On the bottom of the ADF cover, inspect the
ADF cover closed sensor actuator. Does it
move freely?
5 Fix the actuator so it moves freely.
Does this fix the problem?
6 Remove the ADF rear cover and inspect the
ADF cover closed sensor for dirt and debris.
Is there dirt and debris present?
7 Remove the ADF rear cover, and clean the
dirt and debris from the sensor.
Does this fix the issue?
8 Inspect the connections on the ADF relay
card in the ADF. Are all the connections
properly connected?
9 Check the ADF cable for continuity. Is there
continuity?
10 Check for signals or voltages from J17 on
the ICC card. Pin 11 and 12 should measure
+24VDC. Pin 14 should measure +5VDC.
Are there signals or voltages present?
Yes
Go to step 3.
Issue resolved
Go to step 4
3-28.
Go to step 6.
Issue resolved.
Go to step 7.
Issue resolved.
Go to step 9.
Go to step 10.
Replace the ADF.
7541-03x
No
Go to step 2.
Go to step 3.
Go to step 8.
Go to step 5.
Go to step 6.
Go to step 8.
Go to step 8.
Secure all the connections.
Replace the ADF cable.See
"ADF cable" on
page 4-128.
Replace the ICC card.
2-81
Diagnostic information
Previous
Next
Go Back