Option Tray Acm Motor Service Check; Option Tray Controller Card Service Check; Symptoms; Base Printer Symptoms - Lexmark MS310 Series Service Manual

Option tray ACM motor service check

Action
Step 1
Check the cable J11 on the option tray controller card.
Is it properly connected?
Step 2
a
Remove the option tray insert and bypass the tray present sensor.
b
POR into the Diagnostics Menu and perform a feed test:
Diagnostics Menu > Feed Test > choose an option tray
c
Check the ACM for proper operation.
Does the ACM freely rotate three times before displaying a jam message?
Step 3
Is the ACM gear free of wear or damage?

Option tray controller card service check

Action
Step 1
Check all connections to the option tray controller card.
Are the properly connected?
Step 2
Check printer's firmware level.
Is it up to date?
Step 3
Replace the option tray.
Does the error remain?

Symptoms

Base printer symptoms

Symptom
• Control panel LEDs do not illuminate
•
Control panel buttons do not respond
Action
Go to "Control panel service check" on page
Diagnostic information
108
Yes No
Go to step 2. Reseat the cable.
Go to step 3. Replace the ACM
assembly. See
assembly removal" on
page
Contact the next level Replace the ACM
of support. assembly. See
assembly removal" on
page
Yes No
Go to step 2. Reseat the cables.
Go to step 3. Update the firmware.
Contact the next level The problem is solved.
of support.
111.
4514-220, -230
"ACM
216.
"ACM
216.