Welding Data Memory - ESAB Caddyt Arc 150i Service Manual

WELDING DATA MEMORY

Four different sets of welding data parameters can be stored in the machine's memory:
two for TIG welding and two for MMA welding.
Press button or
the green LED shines constantly, and then starts flashing when the data has been saved.
To switch between the predefined settings, press button
In the TIG mode, the data memory can also be changed by briefly pressing the torch switch,
irrespective of wether welding is in progress or not.
Press to activate this function, activated function is indicated by the green LED.
Note: if change of parameter memory by the torch switch is activated, the remote control
unit can not be activated in MMA mode nor in TIG mode.
If four--stroke control mode has been selected, a brief depression of the torch switch will
change welding data memory. The same applies for two--stroke control mode if welding is
not in progress.
When welding with two--stroke control, welding data memory can be changed by briefly
releasing the welding torch switch.
The welding data memory is battery--backed, so that the settings remain even if the
machine has been switched off or disconnected from the mains.
MAINTENANCE
Regular maintenance is important for safe, reliable operation.
Note!
All guarantee undertakings from the supplier cease to apply if the customer himself
attempts any work in the product during the guarantee period in order to rectify any faults.
The CaddyTig 150 requires little maintenance. In normal cases, it is sufficient to blow it
clean using dry compressed air once a year, but this should be done more often if it is set
up in a dusty, dirty area.
Cleaning the dust filter
Remove the fan grille.
S
Release the dust filter.
S
Blow the filter clean
S
with compressed air
(reduced pressure).
Replace the fan grille
S
with the dust filter.
ct27ie1
for 5 seconds to store the data in the memory. At the beginning
Removing the filter
- - 61 - -
CaddyTig 150
or
S0740 800 161/E061205/P66