Caddytig 150 - ESAB Caddyt Arc 150i Service Manual

CaddyTig 150

OPERATION
General safety regulations for the handling of the equipment can be found on page 52.
Read through before you start using the equipment!
Connections and control devices
1. Control panel
2. TIG: Return cable connection (+)
MMA: Welding cable connection (+)
3. Remote control unit connection
4. MMA: Return cable connection (--)
5. TIG torch connection (--)
6. Connection for gas to the TIG torch
7. Connection for the TIG torch switch
8. Connection for gas from gas bottle
9. Mains cable
10. Main power supply switch
Control panel
The control panel comprises a display, setting knob, LEDs and pushbuttons. Using the
pushbuttons, it is possible to move between the various functions. The selected function is
indicated by the relevant LED lighting up.
1. Selection of current (A) or voltage (V)
indication during welding.
2. Indicating lamp, mains power supply On.
3. Remote control unit On / Off.
4. Indicating lamp, overheating.
5. Display.
6. Indication of the parameter that is shown in
the display, Ampere, Volt or seconds.
7. Knob for setting data.
8. Selection of TIG
welding mode.
9. Selection of TIG DC or TIG pulse welding.
10. Selection of TIG HF start
11. Selection of TIG 2--stroke
12. TIG welding parameter settings, see page 59.
13. Selection buttons for the TIG welding parameters, see page 59.
14. Selection buttons for the welding parameter memory, see page 61.
15. Change of parameter memory controlled by the TIG torch trigger, see page 61.
Note: if a remote control unit is activated, the parameter memory can not be controlled by the TIG
torch trigger.
ct27ie1
or MMA
or TIG LiftArc start
or TIG 4--stroke
.
control mode.
- - 56 - -
CaddyTig 150
S0740 800 161/E061205/P66