Full/Half Duplex Setting - Allied Telesis AT-RS710TX Installation Manual

Full/Half Duplex Setting

You can configure each 10 Mbps port on the following switch models for full or
half duplex transmission:
AT-RS718TX, ports 1-16
AT-RS710TX, ports 1-8
The DIP switches are located in the rear panel and are set in the factory for half
duplex. Each numbered DIP switch corresponds to the 10 Mbps port on the
front panel. Figure 8 shows a close-up of the AT-RS710TX's rear panel as an
example.
Figure 8: DIP Switches for Full or Half Duplex Transmission
To configure, push the DIP switches up position for half duplex, or push them
down for full duplex.
All ports on the AT-FS708 model automatically sense full or half
duplex; therefore, this model does not have DIP switches.
AT-RS710TX, AT-RS718TX, and AT-FS708 Switches Installation Guide
1 2 3 4 5 6 7 8
HALF DUPLEX
FULL DUPLEX
Note
15