Resetting The Device; Restoring User Defined Settings To The Device; Notice For Devices That Use Aeris Radios - Multitech MultiConnect rCell 100 User Manual

Resetting the Device

You need:
■
A pin, paperclip, or similar thin object that can fit into the reset hole
The following is the default condition for the RESET button on the Conduit. You can program a change to the
behavior of the button if needed.
To reset the device:
1. Find the hole in the front panel labeled RESET. The reset button is recessed into the case.
2. Use the pin to quickly press and release the RESET button.
The device reboots.

Restoring User Defined Settings to the Device

You can restore user defined settings to your device.
You need:
■
A pin, paperclip, or similar thin object that can fit into the reset hole
1. Locate the hole in the panel labeled RESET. The reset button is recessed into the housing.
2. Use the pin to press in the button for about 3 seconds and then release the reset button.
a. If you do not press in the button long enough, the device will reset, but the user defined settings will
not be restored.
b. If you hold it too long, factory default settings will be restored.
The Conduit mLinux Model is shown. The RESET button is in the same location on both Conduit models.

Notice for Devices that Use Aeris Radios

One component of your device is a radio. A radio algorithm prevents your device from repeatedly attempting to
connect to the network when the radio:
■
Cannot establish a packet data connection or
■
Fails to access the application server.
When writing applications for your devices, ensure that your applications do not interfere with the radio's
connection retry algorithm. If you fail to do so, Aeris might block network access for your devices.
After your devices reach the end of their commercial lifespan, you must remove them from the Aeris network. To
do so, remove power from the devices and remove their antennas. If your devices continue to attempt to register
with the network after you cancel device subscriptions, Aeris can bill you for any traffic generated by those
devices.
®
MultiConnect rCell 100 MTR-H5 User Guide
CHAPTER 4 INSTALLING THE ROUTER
25