Installing The Sim Card; Setting Up Wi-Fi And Gps; Resetting The Device - Multitech MultiConnect rCell 100 Series User Manual

Note: If you need remote access to your MultiConnect device over the Internet for remote configuration,
ensure that your wireless network provider has provisioned mobile terminated data and fixed or dynamic
public IP address in which they can configure the network to redirect any incoming connection to that
predefined IP.

Installing the SIM Card

If you want to operate the router on a GSM/HSPA network, install a SIM card (Subscriber Identity Module).
To install the SIM:
1. Locate the SIM card slot on the side of the router. The slot is labeled SIM.
2. Push the SIM card into the slot until it snaps into place.
3. To remove the SIM, push the edge of the card in. When released, the card pops out of the device.

Setting up Wi-Fi and GPS

Some models have Wi-Fi capability. If your device supports this feature, you need to use the device's web
management interface to enable Wi-Fi. Then, see the online help file for information on working with Wi-Fi.
If your model can support a GPS, also see the online help file for information on working with a GPS.

Resetting the Device

To reset the device, when desired:
1. Find the hole in the panel labeled RESET. The reset button is recessed into the case.
®
MultiConnect rCell 100 Series Router User Guide
INSTALLING AND USING THE ROUTER
15