Multitech MultiConnect rCell 100 User Manual page 27

c. To enable the dial-on-demand feature, check Dial-on-Demand. This indicates to the router that it
should only bring up the PPP connection when there is outgoing IP traffic, and that it would bring
the PPP connection down after a given idle timeout.
d. In the Idle Timeout field, type the amount of idle time that passes before the router times out. If the
time expires, the PPP connection to the Internet is disconnected. The default is 180 seconds.
Note: The Idle Timeout configuration only applys to Dial-on-Demand.
e. In the APN field, type the APN (Access Point Name). The APN is assigned by your wireless service
provider.
Note: This configuration does not apply for rCell units with embedded CDMA/EVDO radios. For these
devices, you will not be able to modify this field.
f. Click Next. Or if you are done making changes, click Finish.
7. In the PPP Authentication panel:
a. From Type, select the authentication protocol type used to negotiate with the remote peer: pap,
chap, or pap-chap. The default is pap-chap.
b. In the Username field, type user name with which the remote peer authenticates. You can leave this
field blank, if desired. Username is limited to 60 characters.
c. In the Password field, type the password with which the remote peer will authenticate. You can
leave this field blank, if desired. Password is limited to 60 characters.
8. Click Finish.
®
MultiConnect rCell 100 MTR-H5 User Guide
CHAPTER 5 USING THE WIZARD TO CONFIGURE YOUR DEVICE
27