Motor Calibration; Paper Prompts; Env Prompts; Action For Prompts - Lexmark C734 Service Manual

Motor Calibration

This test is run to calibrate the leading edge of the paper to each transfer station.
Press Select
eight blank pages and then returns to the Config Menu.
Note: This test should be run at 600 dpi resolution and with duplex disabled.

Paper Prompts

Controls the source the printer selects for a change paper source message. The printer displays the change
paper source message based on the size of the paper requested and not by the paper type.
Selections include Auto, MP Feeder, and Manual Paper. Multi-Purpose Feeder is only available on some printer
models.
Note: If the Configure MP setting is changed to Manual, a power-on reset is performed, and the value of the
Paper Prompts menu item before the power-on reset was Multi-Purpose Feeder, then when the printer restarts,
the printer automatically changes the Paper Prompts setting to Manual Paper.
Load Manual overrides that would result in a change paper message are disabled for Paper or Env prompts that
are set to Manual, Manual Paper, or Manual Env.

Env Prompts

Controls the source the printer selects for a change envelope source message. The printer displays the change
envelope message based on the size of the envelope requested and not by the envelope type.
Selections include Auto, MP Feeder, and Manual Env. MP Feeder is only available on some printer models.
Note: If the Configure MP setting is changed to Manual, and a power-on reset is performed, and the value of
the Env Prompts menu item before the power-on reset was MP Feeder, then when the printer restarts, the
printer automatically changes the Env Prompt setting to Manual Env.
Load Manual overrides that would result in a change paper message are disabled for Paper or Env prompts that
are set to Manual, Manual Paper, or Manual Env.

Action for Prompts

This setting gives the user the option of having the printer resolve change prompt situations without requiring
any user assistance. If the Prompt user value is selected, the printer displays change prompts if the job does
not match the media in the selected source. The user must select another source or change the paper. If
Continue or Use current is selected, the printer acts as if the user made the selection Continue or
Use current and continues without user intervention, in most cases.

Jobs on Disk

Lets the user select whether or not the printer deletes all buffered jobs on the hard disk. This menu item only
appears if a hard disk is installed. It appears even if no buffered jobs exist on the hard disk.
Selections include Do Not Delete and Delete.
Note: Delete does not remove Print and Hold jobs. Use Remove Held Jobs in the Utilities Menu (user menu)
to delete these jobs.
to select Motor Calibration from the Config Menu. Calibrating displays, and the printer prints
5026
3-29
Diagnostic aids