5026
Step
Questions / actions
2
1. Remove the fuser. See
on page
4-90.
2. Check the AC and DC autoconnects on
both the fuser and the printer for damage.
Fuser autoconnects
AC autoconnect
Are the connections damaged?
3
Replace the fuser. See
page
4-90.
Does the error clear?
4
Turn the printer off, and then remove the
fuser. Check the camshaft follower on the
right side. If the camshaft follower (A) is
above the crescent-shaped groove, it needs
to be pressed down into the proper location.
A
Is the camshaft follower on the right side
properly placed in the grove?
2-40
Service Manual
"Fuser removal"
DC autoconnect
On printer
"Fuser removal" on
Yes
Replace the appropriate
cable. See
"Fuser AC
cable removal" on
page 4-91
or
"Fuser DC
cable removal" on
page
4-92.
Problem resolved.
Go to step 5.
No
Go to step 3.
Go to step 4.
Press the camshaft
follower into the grove.