Lexmark C734 Service Manual page 53

Error code
200.25
200.30
201.02
201.06
201.07
Description
Input sensor is made when tray 1 is
installed.
Possible causes:
• Improper placement of paper in
tray 1
• Damaged input sensor flag or
input sensor
• Faulty system board
Paper hit input sensor too soon.
Possible causes:
• Incorrect paper loading.
• Damaged input sensor flag or
input sensor.
• Faulty system board.
Bubble sensor active when printing
started.
Possible causes:
• Paper jam leaving page over
sensor.
• Damaged bubble sensor.
• Damaged fuser autoconnect.
• Faulty fuser DC cable connection.
• Faulty fuser.
• Faulty system board.
Paper is jammed between the input
sensor and the exit sensor.
Possible causes:
• Damaged paper exit sensor or
paper exit sensor flag
• Transport belt module failure
• Aligner failure
• Damaged fuser autoconnect
• Faulty fuser DC cable connection
• Faulty fuser
• Faulty system board
Exit sensor is made early.
Possible causes:
• Damaged paper exit sensor or
paper exit sensor flag
• Damaged fuser autoconnect
• Faulty fuser DC cable connection
• Faulty fuser
• Faulty system board
Action
• Fan media, and stack flat in the tray or
multipurpose feeder.
• Properly set media restraints in the paper tray.
• If clearing a paper jam does not fix the problem,
go to "Input sensor service check" on
page 2-125.
• Fan the media, and then stack flat in the tray.
• Check for anything in the paper path that might
cause the paper to jam.
• The input sensor may not be functioning
properly. Go to "Input sensor service check"
on page 2-125.
1. Clear away anything in the paper path that might
cause the paper to jam.
2. Ensure proper media is set for the type of paper
used.
3. Fan media, and stack flat in the tray.
4. Properly set media restraints in the paper tray.
If the problem persists, go to
service check" on page 2-120.
• Check for anything in the paper path that might
cause the paper to jam.
• Go to "201.06, 201.31—Paper Jam error
service check" on page
• Check for anything in the paper path that might
cause the paper to jam.
• The fuser exit sensor may not be functioning
properly. Go to "Exit sensor service check"
on page 2-123.
Diagnostic information
5026
""Bubble sensor
2-60.
2-19