Jeep 2015 Cherokee Operating Information Manual page 225

brake retraction, to service the rear foundation
brakes (brake pads, calipers, rotors, etc.).
For further information, refer to "Electric Parking
Brake (EPD)" in "Starting and Operating."
Lights
After pressing the Lights button on the touch-
screen the following settings will be available.
• Headlight Off Delay
When this feature is selected, it allows adjust-
ment of the amount of time the headlights
remain on after the engine is shut off. To change
the Headlights Off Delay setting, press the "+"
or "-" button on the touchscreen to select your
desired time interval, and choose either 0 sec,
30 sec, 60 sec or 90 seconds. Press the back
arrow button on the touchscreen to return to the
previous menu, or push the back button on the
faceplate.
• Headlight Illumination On Approach
When this feature is selected, the headlights will
activate and remain on for 0, 30, 60, or 90
seconds when the doors are unlocked with the
Remote Keyless Entry (RKE) transmitter. To
change the Illuminated Approach status, press
222
the "+" or "–" button on the touchscreen to select
your desired time interval. Press the back arrow
button on the touchscreen to return to the
previous menu, or push the back button on the
faceplate.
• Headlights With Wipers — If Equipped
When this feature is selected, and the headlight
switch is in the AUTO position, the headlights
will turn on approximately 10 seconds after the
wipers are turned on. The headlights will also
turn off when the wipers are turned off if they
were turned on by this feature. To make your
selection, press the Headlights With Wipers
button on the touchscreen, until a check-mark
appears next to setting, showing that setting
has been selected. Press the back arrow button
on the touchscreen to return to the previous
menu, or push the back button on the faceplate.
• Auto Dim High Beams — If Equipped
When this feature is selected, the high beam
headlights will deactivate automatically under
certain conditions. To make your selection,
press the "Auto High Beams" button on the
touchscreen, until a check-mark appears next
to setting, showing that setting has been se-
lected. Press the back arrow button on the
touchscreen to return to the previous menu, or
push the back button on the faceplate. Refer to
"Lights/Automatic High Beam — If Equipped" in
"Understanding The Features Of Your Vehicle"
for further information.
• Daytime Running Lights — If Equipped
When this feature is selected, the headlights will
turn on whenever the vehicle is set in motion. To
make your selection, press the "Daytime Run-
ning Lights" button on the touchscreen, until a
check-mark appears next to setting, showing
that setting has been selected. Press the back
arrow button on the touchscreen to return to the
previous menu, or push the back button on the
faceplate.
• Flash Lights With Lock
When this feature is selected, the exterior lights
will flash when the doors are locked or unlocked
with the Remote Keyless Entry (RKE) transmit-
ter. This feature may be selected with or without
the sound horn on lock feature selected. To
make your selection, press the "Flash Lights