Jeep 2015 Cherokee Operating Information Manual page 214

Refer to "ParkSense® Rear Park Assist" in
"Understanding The Features Of Your Vehicle"
for system function and operating information.
• Tilt Mirrors In Reverse — If Equipped
When this feature is selected, the exterior
sideview mirrors will tilt downward when the
ignition is in the RUN position and the transmis-
sion shift lever is in the REVERSE position. The
mirrors will move back to their previous position
when the transmission is shifted out of RE-
VERSE. To make your selection, press the "Tilt
Mirrors In Reverse" button on the touchscreen,
and select "On" or "Off." Press the back arrow
button on the touchscreen to return to the
previous menu.
• Blind Spot Alert — If Equipped
When this feature is selected, the Blind Spot
Alert feature can be set to Off, Lights or Lights
and Chime. The Blind Spot Alert feature can be
activated in Lights mode. When this mode is
selected, the Blind Spot Monitor (BSM) system
is activated and will only show a visual alert in
the outside mirrors. When Lights & Chime mode
is activated, the Blind Spot Monitor (BSM) will
show a visual alert in the outside mirrors as well
as an audible alert when the turn signal is on.
When Off is selected, the Blind Spot Monitor
(BSM) system is deactivated. To change the
Blind Spot Alert status, press the "Off," "Lights"
or "Lights & Chime" button on the touchscreen.
Then press the back arrow button on the touch-
screen.
NOTE:
If your vehicle has experienced any damage
in the area where the sensor is located, even
if the fascia is not damaged, the sensor may
have become misaligned. Take your vehicle
to an authorized dealer to verify sensor
alignment. A sensor that is misaligned will
result in the BSM not operating to specifica-
tion.
• ParkView® Backup Camera Active Guide
Lines — If Equipped
When this feature is enabled, active (dynamic)
grid lines are overlaid on the Rear Backup
Camera image to illustrate the width of the
vehicle and its projected back up path based on
the steering wheel position. A dashed center
line overlay indicates the center of the vehicle to
assist with parking or
hitch/receiver.
• ParkView® Backup Camera Fixed Guide
Lines — If Equipped
When this feature is enabled, fixed (static) grid
lines are overlaid on the Rear Backup Camera
image to illustrate the width of the vehicle.
• ParkView® Backup Camera Delay
When this feature is enabled, it will allow the
ParkView® Backup Camera display to remain
on while in drive for up to 10 seconds, or 8 mph
(13 km/h).
• Rain Sensing Auto Wipers
When this feature is selected, the system will
automatically activate the windshield wipers if it
senses moisture on the windshield. To make
your selection, press the "Rain Sensing" button
on the touchscreen, and select "On" or "Off."
Press the back arrow button on the touchscreen
to return to the previous menu.
aligning to a
211