Driver Memory Seat - If Equipped; Programming The Memory Feature - Jeep 2015 Cherokee Operating Information Manual

DRIVER MEMORY SEAT — IF
EQUIPPED
This feature allows the driver to store up to two
different memory profiles, for easy recall
through a memory switch. Each memory profile
contains desired position settings for the driver
seat and side mirrors and a set of desired radio
station presets.
The memory switch is located on the driver's
side door panel. The switch contains 3 buttons,
a S (SET) button to activate the memory save
function, the number (1) memory button and the
number (2) memory button. The memory switch
allows the driver to recall either of the two
pre-programmed memory profiles by pressing
the appropriate number button on the switch.
Driver Memory Switch

Programming The Memory Feature

To create a new memory profile, perform the
following:
NOTE:
Saving a new memory profile will erase an
existing profile from memory.
1. Cycle the vehicles ignition to the ON posi-
tion.
2. Adjust all memory profile settings to desired
preferences (i.e., seat, side mirror and radio
station presets).
3. Press and release the SET button on the
memory switch, then press the number (1)
button within five seconds. The Electronic
Vehicle Information Center (EVIC) or Driver
Information Display (DID), will display which
memory position is being set.
If desired, a second memory profile can be
stored into memory as follows:
1. Cycle the vehicles ignition to the ON posi-
tion.
2. Adjust all memory profile settings to desired
preferences (i.e., seat, side mirror and radio
station presets).
3. Press and release the SET button on the
memory switch, then press the number (2)
button within five seconds. The EVIC/DID will
display which memory position is being set.
87