To Set A Desired Acc Speed; To Cancel; To Turn Off; To Resume - Jeep 2015 Cherokee Operating Information Manual

To Set A Desired ACC Speed

When the vehicle reaches the speed desired,
push the SET + button or the SET - button and
release. The EVIC/DID will display the set
speed.
If the system is Set when the vehicle speed is
below 19 mph (30 km/h), the Set Speed shall be
defaulted to 19 mph (30 km/h). If the system is
Set when the vehicle speed is above 19 mph
(30 km/h), the Set Speed shall be the current
speed of the vehicle.
NOTE:
ACC cannot be set if there is a stationary
vehicle in front of your vehicle in close
proximity.
Remove your foot from the accelerator pedal. If
you do not, the vehicle may continue to accel-
erate beyond the set speed. If this occurs:
• The message "DRIVER OVERRIDE" will dis-
play in the EVIC/DID.
• The system will not be controlling the distance
between your vehicle and the vehicle ahead.
The vehicle speed will only be determined by
the position of the accelerator pedal.
106

To Cancel

The following conditions cancel the system:
• The brake pedal is applied.
• The CANCEL button is pressed.
• An Anti-Lock Brake System (ABS) event
occurs.
• The shift lever/gear selector is removed from
the Drive position.
• The Electronic Stability Control/Traction Con-
trol System (ESC/TCS) activates.
• The vehicle parking brake is applied.
• Driver seatbelt is unbuckled at low speeds.
• Driver door is opened at low speeds.
• A Trailer Sway Control (TSC) event occurs.
• The driver switches ESC to full-off mode.

To Turn Off

The system will turn off and clear the set speed
in memory if:
• The Adaptive Cruise Control (ACC) ON/OFF
button is pressed.
• The Normal (Fixed Speed) Electronic Speed
Control ON/OFF button is pressed.
• The ignition is turned OFF.
• You switch to Four-Wheel Drive Low.

To Resume

If there is a set speed in memory press the RES
(resume) button and then remove your foot from
the accelerator pedal. The EVIC/DID will display
the last set speed.
NOTE:
• If your vehicle stays at standstill for lon-
ger than two seconds, then the driver will
either have to press the RES (resume)
button, or apply the accelerator pedal to
reengage the ACC to the existing Set
Speed.
• ACC cannot be resumed if there is a
stationary vehicle in-front of your vehicle
in close proximity.