Jeep 2015 Cherokee Operating Information Manual page 291

• NEUTRAL = 1.2 mph (2 km/h)
• PARK = SSC remains enabled but not active
NOTE:
• These SSC default set speeds are depen-
dent on hill grade. That is the steeper the
grade of the hill the vehicle travels on the
lower the values of the set speed will be
for all listed gears, with the minimal value
being .6 mph (1 km/h).
• During SSC the ERS +/- shifter input is
used for SSC target speed selection but
will not affect the gear chosen by the
transmission. During SSC the transmis-
sion will shift appropriately for the driver-
selected set speed and corresponding
driving conditions.
• SSC performance is influenced by the
Terrain Select mode. This difference may
be notable to the driver and may be per-
ceived as a varying
aggressiveness.
288
Driver Override:
The driver may override SSC activation with
throttle or brake application at any time.
Deactivating SSC
SSC will be deactivated but remain available if
any of the following conditions occur:
• Driver overrides SSC set speed with throttle
or brake application.
• Vehicle speed exceeds 20 mph (32 km/h) but
remains below 40 mph (64 km/h).
• Vehicle is shifted to park.
Disabling SSC
SSC will deactivate and be disabled if any of the
following conditions occur:
• The driver presses the SSC switch.
• The driveline is shifted out of 4WD Low
Range.
• The parking brake is applied.
level of
• Driver door opens.
• The vehicle is driven greater than 20 mph
(32 km/h) for greater than 70 seconds.
• The vehicle is driven greater than 40 mph
(64 km/h) (SSC exits immediately).
Feedback To The Driver:
The instrument cluster has an SSC icon and the
SSC switch has an LED which offer feedback to
the driver about the state SSC is in.
• The cluster icon and switch lamp will illumi-
nate and remain on solid when SSC is en-
abled or activated. This is the normal oper-
ating condition for SSC.
• The cluster icon and switch lamp will flash for
several seconds then extinguish when the
driver presses the SSC switch but enable
conditions are not met.
• The cluster icon and switch lamp will flash for
several seconds then extinguish when SSC
deactivates due to excess speed.
• The cluster icon and switch lamp will flash
then extinguish when SSC deactivates due
to overheated brakes.