Flow-Control, Ieee 802.3X Standard - GarrettCom Magnum 10KG Installation And User Manual

Magnum 10KG Managed Switch Installation and User Guide
General information -
Auto-negotiation per-port for 802.3u-compliant switches occurs when:
-- the devices at both ends of the cable are capable of operation at either
10Mb or 100Mb speed and/or in full- or half-duplex mode, and can
send/receive auto-negotiation pulses, and . . .
-- the second of the two connected devices is powered up*, i.e., when
LINK is established for a port, or
-- the LINK is re-established on a port after being lost temporarily.
•
NOTE – Some NIC cards only auto-negotiate when the computer system
that they are part of is powered up. These are exceptions to the "negotiate at
LINK – enabled" rule above, but may be occasionally encountered.
When operating in 100Mb half-duplex mode, cable distances and hop-counts
may be limited within that collision domain. The Path Delay Value (PDV) bit-times must
account for all devices and cable lengths within that domain. For Magnum 10KG Fast
Ethernet switched ports operating at 100Mb half-duplex, the bit time delay is 50BT.
4.3

Flow-control, IEEE 802.3x standard

Magnum 10KG Switches incorporate a flow-control mechanism for Full-
Duplex mode. The purpose of flow-control is to reduce the risk of data loss if a long burst
of activity causes the switch to save frames until its buffer memory is full. This is most
likely to occur when data is moving from a 100Mb port to a 10 Mb port and the 10Mb
port is unable to keep up. It can also occur when multiple 100Mb ports are attempting to
transmit to one 100Mb port, and in other protracted heavy traffic situations.
Magnum 10KG Switches implement the 802.3x flow control (non-blocking) on
Full-Duplex ports, which provides for a "PAUSE" packet to be transmitted to the sender
when the packet buffer is nearly filled and there is danger of lost packets. The
transmitting device is commanded to stop transmitting into the 10KG Switch port for
sufficient time to let the Switch reduce the buffer space used. When the available free-
buffer queue increases, the Switch will send a "RESUME" packet to tell the transmitter to
start sending the packets. Of course, the transmitting device must also support the 802.3x
flow control standard in order to communicate properly during normal operation.
Note: When in Half-Duplex mode, the 10KG Switch implements a back-pressure
algorithm on 10/100 Mb ports for flow control. That is, the switch prevents frames from
entering the device by forcing a collision indication on the half-duplex ports that are
receiving. This temporary "collision" delay allows the available buffer space to improve
as the switch catches up with the traffic flow.
www GarrettCom com . .
29
07/12