GarrettCom Magnum 10KG Installation And User Manual page 3

Magnum 10KG Managed Switch Installation and User Guide
This equipment generates uses and can radiate frequency energy and if not
installed and used properly in strict accordance with the manufacturer's instructions,
may cause interference to radio communication. It has been tested and found to comply
with the limits for a Class A computing device in accordance with the specifications in
Subpart J of Part 15 of FCC rules, which are designed to provide reasonable protection
against such interference when operated in a commercial environment. Operation of this
equipment in a residential area is likely to cause interference, in which case the user, at
their own expense, will be required to take whatever measures may be required to correct
the interference.
This Class A digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Cet appareil respecte toutes les exigences du R
appareil est Classe A.
Electrical Safety requirements:
1. This product is to be installed Only in Restricted Access Areas
(Dedicated Equipment Rooms, Electrical Closets, or the like).
2. All products shall be installed with a readily accessible disconnect device in
the building installation supply circuit to the product.
3. This product shall be provided with a maximum 10A DC Listed fuse or
circuit breaker in the supply circuit when connected to a 48V
centralized source.
4. The external power supply for DC units shall be Listed, Direct Plug In
power unit, marked Class 2, or listed ITE Power Supply, marked LPS,
which has suitably rated output voltage (i.e. 24VDC or 48VDC) and suitable
rated output current.
5. Product does not contain user replaceable fuses. Any internal fuses can
ONLY be replaced by GarrettCom personnel through the RMA process.
6. The chassis main earthing screw shall be connected to the supply protective
earthing conductor.
This equipment has the ordering option of being supplied to the purchaser without a
Fiber Optic Class 1 Laser transceiver included. In this case, it is the responsibility of the
purchasing party to apply the proper labeling required to the product, in accordance
with US 21CFR Subchapter J Part 1040, if a transceiver is installed by the purchaser.
(See label example below)
www GarrettCom com .
Federal Communications Commission
Radio Frequency Interference Statement
Canadian Emissions Statement
Complies with FDA radiation performance
standards, 21CFR Subchapter J.
.
é
glement sur le mat
ii
07/12
é
riel du Canada. Cet