Electrical Connection - Kranzle therm 895 Operating Instructions Manual

Electrical connection

The voltage given on the specification plate must match the mains voltage.
The machine is supplied with a power cable and plug.
The plug must be connected to a properly installed electrical socket with earthing and
have a 30 mA FI fault current safety switch. The socket must have a neutral 16A fuse on
the mains side.
If an extension cable is used, it must have an earth line that is properly
connected to the plug connections. The lines in the extension cable must
have a cross section of at least 1,5 mm². The plug connections must be of
spray protected design and may not lie on a wet surface. (If the extension
cable is longer than
10 m the minimum cross section is 2,5 mm²)
Important!
Extension cables that are too long cause a drop in the voltage and thus interruptions in
operation. If you are using a cable drum, the cable must always be fully unwound.
Quick operating instructions
are also on the machine.
1. Connect the high pressure hose with the spray gun and lance to the machine.
2. Connect the water supply and turn on the tap.
3. Connect to the electrical supply.
4. Switch on the machine with the spray gun open and start the washing procedure.
5. When using the machine as a cold water high pressure cleaner:
ignition "OFF"
6. When using the machine as a hot water high pressure cleaner:
ignition "ON"
7. When using the machine as a hot water high pressure cleaner: preselect the water
temperature ("target" temperature) using the "+" und "-" buttons. The current water
temperature is shown in the "ACTUAL" display field.
8. A blinking "OIL" display on the temperature control panel indicates that there is
less than the minimum required quantity of heatng oil, and that the oil tank must be
refilled.
High pressure hose line and spray equipment
The high pressure hose line and spray equipment supplied with the machine are made
of high quality material specially adapted for the operating conditions of the machine, and
are properly marked.
10
Description