Adjusting The Pressure; Anti-Freeze Protection - Kranzle therm 895 Operating Instructions Manual

In the interests of the environment and to keep expenditure down, we
recommend sparing use of detergent. Please observe the
recommendations of the detergent manufacturer.
After using detergents, rinse the machine for approx 2 minutes by
pressing the trigger of the spray gun.

Adjusting the pressure

- There are two ways to adjust the working pressure:
1. Using the pressure control valve (see page 4) directly on the control and safetyblock
* Turn the handwheel (page 4; no. 1) to the left to decrease pressure.
* Turn the handwheel to the right to increase pressure.
2. Using the pressure control in the handgun (see page 7)
* Turn the red ring to the left to decrease pressure.
* Turn the red ring to the right to increase pressure.
Decommissioning
- Switch off the master switch (position "0")
- Pull the plug out of the power socket.
- Turn off the water supply.
- Open teh gun until the pressure is gone.
- Lock the gun
- Disconnect the water hose.
- Slacken the connections of the high pressure hose and gun and unscrew the high
pressure hose from the machine.

Anti-Freeze Protection

The machine is normally still partially filled with water after work has been
completed. It is therefore necessary to take special precautions to protect the
machine from frost.
- Completely empty the machine of water.
Disconnect the machine from the water supply and switch off the ignition.
Switch on the master switch and open the gun. The pump now presses the
remaining water out of the heating element.
Do not allow the machine to run for longer than a miniute without water.
- Fill the machine with anti-freeze
If the machine is not in use for lengthy periods of time, it is advisable to
pump anti-freeze into the machine, especially in winter..
However, the best protection against frost is to keep the machine in a place that is
safe from frost.
Decommissioning
13