Water Connection; High Pressure Connection - Kranzle therm 895 Operating Instructions Manual

If spare parts are required, only properly marked components approved by the
maker should be used. High pressure hoses and spray equipment must be
connected so that they are pressure-tight. The high pressure hoses should
not be driven over, pulled excessively or twisted. Do not pull the hose over
sharp edges, since this will invalidate the warranty.
Commissioning
* Secure the machine by applying the brake.
* Open the right cover of the machine (without chimney) and check
the oil level of the high pressure pump.
Do not start the machine if there is no oil in the sight glass.
Fill oil if necessary.
* Fill the fuel tank with light heating oil prior to use.
Use EL heating oil or diesel fuel only
Unsuitable fuels, such as petrol, may not be used (danger of explosion)

Water connection

Connect the machine to a water tap using a hose of at least 1/2" and turn on the
tap.
The water tank in the machine fills up. When the tank is full, the built-in float valve
closes the water inlet.
Use clean water only!
Follow the instructions of the local water supply utility.
Connection of the machine to drinking water mains must be in
accordance with DIN 1988.

High pressure connection

Connect the high pressure hose to the handgun.
Unwind the hose so that it is free of loops and connect it to the handgun and the
machine.
Check that all screw-type connections are pressure-tight.
Commissioning
11