Electrical Connection - Kranzle therm 890 Operating Manual

Electrical connection

The voltage given on the specification plate must match the mains voltage.
The machine is supplied with a power cable and plug.
The plug must be connected to a properly installed electrical socket with
earthing and have a 30 mA FI residual current circuit breaker. The socket
must have a neutral 16A fuse on the mains side.
If an extension cable is used, it must have an earth line that is properly connected to the
plug connections. The lines in the extension cable must have a cross section of at least
1,5 mm². The plug connections must be of spray protected design and may not lie on a
wet surface. (If the extension cable is longer than 10 m the minimum cross section is
2,5 mm²)
Important!
Extension cables that are too long cause a drop in the voltage and thus
interruptions in operation. If you are using a cable drum, the cable must
always be fully unwound.
Brief operating instructions
To be found on the machine.
1. Connect the high pressure hose with the spray gun and lance to the machine.
2. Connect the water supply and turn on the tap.
3. Connect to the electrical supply.
4. Switch on the machine with the spray gun open and start the washing procedure.
If the system has to be de-aerated (machine vibrates), open and close the gun
several times.
5. When using the machine as a cold water high pressure cleaner:
ignition "OFF" - Set thermostat with rotary control switch to 0 °C.
6. When using the machine as a hot water high pressure cleaner:
ignition "ON" - Set thermostat with rotary control switch to min. 40 °C
7. When using the machine as a hot water high pressure cleaner:
preselect the water temperature with thermostat to min. 40° C
High pressure hose and spray equipment
The high pressure hose and spray equipment supplied with the machine are made of
high quality material specially adapted for the operating conditions of the machine, and
are properly marked.
If spare parts are required, only properly marked components approved by
the maker should be used. High pressure hoses and spray equipment
must be connected so that they are pressure-tight. The high pressure
hoses should not be driven over, pulled excessively or twisted. Do not pull
the hose over sharp edges, since this will invalidate the warranty.
12
Commissioning