Booting And Shutting Down Microsoft Windows; Microsoft Windows Support For Cell Local Memory - HP rp7440 Service Manual

2. At the OpenVMS command line (DCL) issue the @SYS$SYSTEM:SHUTDOWN command and
specify the shutdown options in response to the prompts given.
>@SYS$SYSTEM:SHUTDOWN
How many minutes until final shutdown [0]:
Reason for shutdown [Standalone]:
Do you want to spin down the disk volumes [NO]?
Do you want to invoke the site-specific shutdown procedure [YES]?
Should an automatic system reboot be performed [NO]? yes
When will the system be rebooted [shortly via automatic reboot]:
Shutdown options (enter as a comma-separated list):
REBOOT_CHECK
SAVE_FEEDBACK
DISABLE_AUTOSTART
POWER_OFF
Shutdown options [NONE]:
%SHUTDOWN-I-OPERATOR, this terminal is now an operator s console
...
NOTE:
The SYS$SYSTEM:SHUTDOWN.COM command prompts establish the shutdown behavior,
including the shutdown time and whether the system is rebooted after it is shut down.
• To perform a reboot for reconfig from OpenVMS I64 running on an nPartition, issue
@SYS$SYSTEM:SHUTDOWN.COM from OpenVMS, and then enter Yes at the "Should
an automatic system reboot be performed" prompt.
• To perform a shutdown for reconfig of an nPartition running OpenVMS I64:
1.
2.

Booting and Shutting Down Microsoft Windows

This section presents procedures for booting and shutting down the Microsoft Windows OS on
cell-based HP Integrity servers and a procedure for adding Windows to the boot options list.
• To determine whether the cell local memory (CLM) configuration is appropriate for Windows,
refer to "Microsoft Windows Support for Cell Local Memory" (page
• To add a Windows entry to the boot options list, refer to
the Boot Options List" (page
• To boot Windows, refer to
• To shut down Windows, refer to

Microsoft Windows Support for Cell Local Memory

On servers based on the HP sx2000 chipset, each cell has a cell local memory (CLM) parameter,
which determines how firmware interleaves memory residing on the cell.
SHUTDOWN -- Perform an Orderly System Shutdown
on node RSNVMS
Check existence of basic system files
Save AUTOGEN feedback information from this boot
Disable autostart queues
Request console to power-off the system
HP OpenVMS I64 currently does not support the POWER_OFF shutdown option.
Issue @SYS$SYSTEM:SHUTDOWN.COM from OpenVMS and enter No at the "Should
an automatic system reboot be performed" prompt.
Access the management processor and, from the management processor Command
Menu, issue the RR command and specify the nPartition. The nPartition you specify
will be put in the shutdown for reconfig state.
110).
"Booting Microsoft Windows" (page
"Shutting Down Microsoft Windows" (page
Booting and Shutting Down Microsoft Windows
109).
"Adding Microsoft Windows to
111).
113).
109