Battery State Indicator; Circuit Breakers; Stand-By Mode - Monaco LaPalma Owner's Manual

The battery state indicator performs two functions. When not hooked to
shore power the Battery State indicator displays the approximate state of
charge of the house batteries. When connected to shore power or operating
from the generator, the lamps indicate what part of the charge cycle the
inverter is in.
(A) Red = Bulk Charge
(B) Yellow = Accept Charge
(C) Green = Float Charge
Battery Charger Circuit Breaker:
The circuit breaker for the charger is located on the front of the inverter.
The breaker is a re-settable breaker in case an over current or short circuit
condition occurs within the Battery Charger circuitry.
AC Out Circuit Breakers:
Two branch circuit breakers are located on the front of the inverter. One
of the branch circuit breakers supplies AC power to various receptacle.
The other breaker supplies AC power to the microwave.
The inverter may be placed in "STAND-BY" when hooked to shore
power or operating from the generator. If AC power discontinues, the
inverter activates automatically. When AC power resumes, the inverter will
go back to STAND-BY mode. STAND-BY mode is indicated by the
INVERT status light flashing once every two seconds when hooked to shore
power or operating from the generator.
To enable or disable this feature:
• Press the INVERT button.
NOTE: Remember to disable stand-by mode when not in
use. It may run down the house batteries.
2004 • LaPalma
battery state
Electrical Systems
Battery State
Indicator

Circuit Breakers

Stand-By Mode

8 • 309