Monaco LaPalma Owner's Manual page 340

8 • 340
Headlamp High/Low Beam Changer
To change the headlamps for low beam to high beam, or high to low, pull
the turn signal lever all the way forward, then release.
Wiper/Washer Operation
Push button to wash position and release. Wash solution is delivered
within approximately 5 seconds and wipers will turn on and off
automatically. A continuous wash and wipe is performed as long as wash
button is activated.
When rotating smart stick section from OFF to delay, turn wipers on and
a delay between wipes (ranging from 45 seconds to 2 seconds) will occur.
Delay time changes as stick is turned forward. A continuous low or high
speed can be obtained by rotating section to appropriate position. To turn
wipers off rotate stick to OFF position.
Cruise Control
Cruise control will maintain a speed of about 25 mph (40 km/h) or more
without depressing the accelerator. Cruise control does not work at speeds
below about 25 mph (40 km/h).
Cruise control disengages when the brakes are applied.
To Set Speed - Move slide on smart stick to ON position and drive at
desired speed above 25 mph. Hold desired speed while pressing and then
releasing Set/Coast button. One second after release, remove foot from
accelerator pedal. Increase speed at any time by pressing on the accelerator
pedal. Releasing the accelerator pedal will return to set speed.
To Accelerate - Hold slide switch in Resume/Accel position and the
motorhome will accelerate. Release switch and the motorhome will slow to
set speed. To set speed higher, release slide button and immediately press and
release Set/Coast button as motorhome reaches desired speed.
To Coast - Press and hold Set/Coast button in and allow motorhome to
coast. To set speed lower, release button as motorhome approaches desired
speed.
To Disengage - Depress brake pedal to manually control the motorhome's
speed. Disengage speed control by pushing slide switch to OFF.
Electrical Systems
2004 • LaPalma