Retracting Main Room - Monaco LaPalma Owner's Manual

To Retract the Main Slide-out Room:
• Check for sufficient clearance inside the motorhome before
retracting the slide-out room.
• Clean the floor, if applicable, to ensure there is no dirt or grit
that could result in floor damage during operation.
• Move the driver seat forward.
• Inspect the exterior to ensure there are no sags in the awning
material.
• Remove any debris from the top of the slide-out room.
• Retract the leveling jacks prior to operating the slide-out.
• Turn the ignition switch OFF. The slide-out room will not
operate with the engine running.
• The house batteries should be fully charged.
• The park brake must be applied.
• Ensure all people, pets and objects are clear of the slide-out
room path.
• Press and hold the switch in the IN position. The slide-out room
will move slowly in. To stop the slide-out room, release the
switch. To continue the room movement, push and hold the
switch in.
• Release the switch.
• Rain water can pool on the slide-out awning. Added weight will
cause the awning to sag. Upon retracting the room, the material
can catch between the top of the slide room and the opening of
the motorhome. It will be necessary to retract the room in small
increments, allowing the water time to run off.
• If applicable, place locking bar mechanisms between the wall
and top edge of the slide-out room to lock room in place.
WARNING: If locking bar mechanisms are used, make
sure they are secured tightly before moving motorhome.
Locking bars can come loose and cause personal injury.
NOTE: Be sure you have sufficient clearance on the inside
of the motorhome (driver's seat, etc.) before you retract the
slide-out room. Ensure the floor is clean before you retract
the slide-out room. Trapped dirt or grit under the slide-out
room can scratch the floor surface. Never move the
motorhome with the slide-out room extended.
2004 • LaPalma
Equipment
Retracting
Main Room
5 • 205