Water Pump - Monaco LaPalma Owner's Manual

WATER PUMP

040504
6 • 250
CAUTION: Some water sources develop high water pressure,
particularly in mountainous regions. High water pressure is
anything over 55 psi (pounds per square inch). Excessive water
pressure may cause leaks in water lines and/or damage the water
heater.
The water pump is used to pressurize the fresh water system when not
connected to city water. The water pump is totally automatic and self-prim-
ing, operating on demand as water is used.
The water pump is located in the outside control compartment of the
motorhome.
Do not allow the pump to run when the fresh water supply tank is empty.
Continued operation with a dry tank may open an electrical circuit and/or
damage the water pump.
To Start Pump After Unhooking City Water Supply or First Time use
Proceed as Follows:
• Fill the fresh water tank.
• Open all valves and faucets except the drain valves. This includes hot
and cold water valves, all faucets and the shower.
• Turn the water pump on. Wait for the water lines and the hot water
tank to fill.
• Close each faucet when it delivers a steady stream of water (cold
water faucets first).
Water Systems
WARNING: Before
leaving the motorhome for
extended periods of time
(i.e. overnight or longer)
be sure that the city water
and all water pumps have
been turned off. Damage
from neglect will be
responsibility of the owner
and not the manufacturer.
To operate the water pump,
momentarily press the water pump
switch. The light indicates the water
pump is on. The remote switches are
located on the system panel in the
hallway and on the outside water
control panel. To turn pump OFF,
momentarily press the water pump
switch.
2004 • LaPalma