Monaco LaPalma Owner's Manual page 41

• The unit will display the word CAL. Press the F/C button to enter the
calibration mode. The unit will begin to count down from 60 seconds
and the word CAL will flash. The driver should slowly drive in a
circle during the 60 second count down. If the calibration failed, the
unit will continue to flash CAL. Repeat this step if necessary. If
calibration was successful, the unit will display the word CAL for five
seconds and then return to Ignition ON Operation.
• When you travel outside the set zone, the compass may have reduced
accuracy. To change the zone, repeat the first three steps of this
procedure. After the new zone is set, press the MODE button to skip
calibration. It is not necessary to recalibrate the compass when you
change the zone value.
Sleep Mode Operation:
• Unit enters sleep mode when ignition switch is turned OFF.
• The display is blank and the unit is in a Low Power Mode.
• Unit awakens when the ignition switch is turned ON or enters
CAMPING MODE when the F/C button is pressed for three
seconds.
Camping Mode Operation:
• Unit enters Camping Mode after the F/C button is pressed for three
seconds while unit is in Sleep Mode. Unit will display temperature
and heading for ten seconds and then return to Sleep Mode.
• Repeat procedure as desired.
Nighttime Dimming:
• Display brightness will dim by 50% when headlights are turned ON.
2004 • LaPalma
Driving & Safety
2 • 41