Table of Contents
Advertisement
B.1
Optical Characteristics
The optical characteristics are measured under stable conditions at 25°C (Room
Temperature)
1.
Since the front polarizer is easily damaged, pay attention not to scratch it.
2.
Be sure to turn off the power supply when inserting or disconnecting from the
input connector.
3.
Wipe off water drops immediately. Long contact with water may cause discolor-
ation or spots.
4.
When the panel surface is soiled, wipe it with absorbent cotton or other soft
cloth.
5.
Since the panel is made of glass, it may break or crack if dropped or bumped on
a hard surface.
6.
Since CMOS LSI are used in this module, take care of static electricity and
insure you are grounded to earth-ground when handling.
7.
Do not open or modify the module assembly.
8.
Do not press the reflector sheet at the back of the module in any direction.
9.
In case a module has to be put back into the packing container after it has been
removed, please press the ends of the LED light bar reflector edge softly. Other-
wise the TFT module may be damaged.
10.
At the insertion or removal of the Signal Interface Connector, be sure not to
rotate nor tilt the Interface Connector of the TFT Module.
11.
After installation of the TFT Module into an enclosure, do not twist or bend the
TFT Module even momentarily. When designing the enclosure, it should be
taken into consideration that no bending/twisting forces are applied to the TFT
Module from outside. Otherwise the TFT Module may be damaged.
12.
Small amounts of materials with no flammability grading are used in the LCD
module. The LCD module should be supplied by power which complies with the
requirements of Limited Power Source (IEC60950 or UL1950) or an exemption
should be applied for.
IDK-2108 User Manual
30
Advertisement
Table of Contents
