Touchscreen; Touch Characteristics; Optical Characteristics; Mechanical Characteristics - Advantech IDK-1110WP Series User Manual

4.1

Touchscreen

4.1.1

Touch Characteristics

IDK-1110WP series products use projected capacitive touchscreens.
4.1.2

Optical Characteristics

Item
Transparency
Haze
4.1.3

Mechanical Characteristics

Item
Surface Hardness
Cover Lens Thickness
Overall Thickness
Static Force Required for Breaking the
Glass
Controller and Tail Type
FPC Tail Bending Radius
Holding Force for Tail
Connector Pins & Pitch
Top Surface Finish Type
4.2

Touch Controller

Advantech's IDK-1110WP series projective capacitive touch screen adopts a COF
(Chip on FPC) design so an extra touch control board is not required. This communi-
cates with a PC system directly through USB connectors. The superior design is sen-
sitive, accurate and user friendly.
4.2.1

Electrical Specifications

Item
Positional Accuracy
Operating Voltage
Measurement Resolution
Activation Force
The COF Tail Interface
Power Consumption
Sample Rate
IDK-1110WP User Manual
Specifications
90% 3%
7.0% 3%
Specifications
Mohs 5
1.10mm
1.50±0.20mm
>20kgf
COF (Chip on FPC tail)
R2.5mm
Peeling upward 90deg with 500gw without
impact to electric performance.
5pins, pitch is 1.25mm
Clear
Specifications
The percentage of positional inaccuracy is less than 2.0%
as defined below.
X direction of linearity: ∆x/X *100%.
Y direction of linearity: ∆y/Y *100%
5V
2048
Zero force
USB
Typical – Standby Mode: 26.2 mA / 5V
Active Mode: 41.2 mA / 5V
Sleep Mode: 2.78 mA / 5V
Single Touch 150 sps / Multi (5) touch 100 sps
(Sample-rate is may be effected by different firmware)
20