Table of Contents
Advertisement
5.1
Touchscreen (for IDK-2117R Only)
5.1.1
Touch Characteristics
The touch panel is a resistance type for use with flat displays like an LCD. Once the
operator touches it with a stylus or a finger, the circuit for the touch panel sends coor-
dinate points to a PC from the voltages at the contact points.
5.1.2
Optical Characteristics
Item
Transparency
Haze
5.1.3
Mechanical Characteristics
Item
Operation force
Impact
Static Load
Hardness of surface
FPC peeling strength
FPC bending
5.2
Touch Controller (for IDK-2117R Only)
Advantech's ETM-RES04C Touch Control Board is the ultimate combo board. This
touch panel controller provides optimal performance for 5-wire analog resistive touch
panels. It communicates with a PC system directly through USB and RS-232 connec-
tors. The superior design is sensitive, accurate and is friendly to operate. The touch
panel driver emulates mouse left and right button functions.
5.2.1
Touch Controller Characteristics
Item
Circuit Board Dimension
Power Requirements
Interface
Protocol
Resolution
Report rate
Response time
Attached Cable
IDK-2117 User Manual
Specifications
80%
3%
8.0% 3%
Specifications
≤ 50g
25.0 ɸDIA. Steel Ball/67g
Height=50cm
5000g within 10cm area for 30sec
Pencil hardness 3H.
800g by vertical 90̊
90̊ 10 times up & down
Specifications
20mm x 75mm (0.79inches x 2.95inches)
D.C.+5V (100mA typical,50mV peak to peak maximum ripple
and noise)
Bi-directional RS-232 serial communication
USB: 1.1 Full Speed
No parity,8 data bits,1 stop bit, 9600 baud (N,8,1,9600)
2048 x 2048 resolution
RS232: Max. 180 points/sec
USB: Max. 200 points/sec
Max. 20 ms
RS232: 180cm shielded cable with 9-pin D-sub connector
USB: 180cm shielded cable with USB-A connector
22
Remarks
BYK-Gardner
BYK-Gardner
Remarks
Stylus = R0.8
1 time, no damage
[Impact at center area]
750g, 45̊
Advertisement
Table of Contents
