Advertisement
Dual Mount Universal Kit Aftermarket CMOS Camera with Optional Parking Gridlines
Step 9: Secure Camera Harness to existing vehicle
wiring . This will minimize the chance of binding or otherwise
damaging the harness (Recommended: Wire Ties or Electrical
Tape.)
Step 10: Connect Chassis Harness red wire reverse
wire and black to clean chassis ground.
Step 11: Install aftermarket display/ Navigation
display as per instructions ( if required) .
REQUIRED CONNECTIONS
Wire
Polarity
Function
Color
Red
12v +
Reverse
Black
-
Ground
1: Select and Install Camera Bracket . Choose L icense Plate Bracket o r Alternate Camera Mount Bracket. Place camera in desired position to confirm
fitment (Note: Some states prohibit items blocking the license plate; check local authorities to confirm legal status for your specific application).
License Plate Bracket: Remove vehicle license plate. Reattach license plate securing bracket behind.
Alternate Camera Mount Bracket: R emove camera from License Plate Bracket using supplied Allen wrench. Attach camera to Alternate Camera Mount bracket
and apply supplied self-adhesive foam to mount. Use Template below to locate Alternate Camera mount on the vehicle: Clean vehicle surface and affix by exposing
self-adhesive foam. RECOMMENDED: Permanent attachment using small screws.
2: Measure, mark, and drill ¼" hole for camera harness.
3: Determine location of vehicle power and ground. U sing a vehicle specific service guide and/or wiring diagram and a multi-meter or computer-safe test
light, locate which side of the vehicle contains wires into which you will need to tap for the Power Harness wiring (see Required Connections above).
9002-7601 Instructions 6-10-19
Installation Instructions (Kit # 9002-7601)
OVERVIEW
Connection
Commonly found in kick panel
Good chassis ground
Page 4 of 5
Step 12: Connect the male RCA from the Power
Harness to the "Camera IN" on the aftermarket
display/ Navigation display.
Note: Connection to female RCA connector shown.
Step 13: Test the system. I nspect that all connections are
proper and secure. Clear all loose items removed from the
area around the vehicle and turn ignition key ON to test
system.
Step 14: Adjust Camera angle (if necessary). Loosen
camera screw using supplied Allen wrench to aim the camera.
Tighten screw at desired adjustment.
Step 15: Reassemble vehicle . Follow your disassembly
steps in reverse order, taking care not to bind the harness
wiring when reinstalling.
KB
Advertisement
