Table of Contents
Advertisement
Steps
1.
Slide the chassis intrusion switch into the intrusion switch slot.
2.
Connect the chassis intrusion switch cable to the connector on the Network Daughter Card (NDC)
riser card.
3.
Route the cable through the hook on the NDC riser bracket.
Next steps
1.
Install the NDC.
2.
Install the NDC riser.
3.
Follow the procedure listed in
Related Tasks
Installing the network daughter card
Installing the NDC riser
Cable management tray
The cable management tray is located above the heat sinks. It is used to route and manage the cables
connecting the storage and expansion cards to various connectors on the backplane.
NOTE: Cable management tray also facilitates proper cooling of the system. It helps control airflow
to the processors and the expansion cards on the risers, when the risers are installed.
Removing the cable management tray
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1.
Ensure that you follow the
2.
Follow the procedure listed in
3.
Remove the following:
a.
Memory risers
b.
Cooling fans
c.
Memory riser and fan cage
d.
Memory riser blanks, if installed
Steps
1.
To open the cable management tray, press the release tab.
2.
Remove the cables routed through the cable management tray.
3.
Press the cable management tray hooks to disengage them from the slots on the side of the chassis.
4.
Lift the cable management tray out of the system.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
53
Advertisement
Table of Contents
Troubleshooting
