Installing Memory Modules Into The Memory Riser - Dell PowerEdge R930 Owner's Manual

Figure 18. Removing and installing a memory module
1. memory module
3. memory module ejector (2)
Next steps
1. If you are removing a memory module permanently, install a memory module blank.
NOTE: The procedure for removing and installing a memory module blank is identical to
removing and installing a memory module.
Related Tasks
Removing a memory riser

Installing memory modules into the memory riser

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
WARNING: The memory modules are hot to touch for some time after the system has been
powered down. Allow the memory modules to cool before handling them. Handle the memory
modules by the card edges and avoid touching the components or metallic contacts on the
memory module.
CAUTION: To ensure proper system cooling, memory module blanks must be installed in any
memory socket that is not occupied. Remove memory module blanks only if you intend to install
memory modules in those sockets.
Ensure that you follow the
68
Safety instructions.
2. memory module socket