Removing The Left Expansion Card Riser Blank - Dell PowerEdge R930 Owner's Manual

Card Card type
priority
Fibre Channel 8 Gb
Dual Port (Emulex)
8 Fibre Channel 8 Gb
Single Port
(QLogic)
Fibre Channel 8 Gb
Single Port
(Emulex)
9 1 Gb NICs Dual
Port (Intel)
1 Gb NICs Quad
Port (Intel)
10 External Non-RAID
Controller
NOTE:
(*) indicates that "Slot 1" is not available if the optional left PCIe expansion riser is installed.
(^) indicates that "Slot 9" is not available if the optional right PCIe expansion riser is installed.

Removing the left expansion card riser blank

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you follow the
2. Follow the procedure listed in
Steps
1. Slide the blank toward the side wall of the chassis.
2. Tilt the blank away from the chassis.
3. Press and push the release tab on the PCI retention rocker to release the retention rocker.
4. Lift the blank away from the system.
88
Form factor Slot priority (Two
processors)
Full Height (1/1)*, (2/2)*, 1, 3,
4, 5
Full Height 1, 3, 4, 5
Full Height (1/1)*, (2/2)*, 1, 3,
4, 5
Full Height (1/1)*, (2/2)*, 1, 3,
4, 5
Full Height (1/1)*, (2/2)*, 1, 3,
4, 5
Full Height 1*, 3, 4, 5, (1/1)*,
(2/2)*
Safety instructions.
Before working inside your
Slot priority (Four
processors)
(1/1)*, (2/2)*, (1/9)^,
(2/10)^, 1, 3, 4, 5, 6, 7, 8,
9
1, 3, 4, 5, 6, 7, 8, 9
(1/1)*, (2/2)*, (1/9)^,
(2/10)^, 1, 3, 4, 5, 6, 7, 8,
9
(1/1)*, (2/2)*, (1/9)^,
(2/10)^, 1, 3, 4, 5, 6, 7, 8,
9
(1/1)*, (2/2)*, (1/9)^,
(2/10)^, 1, 3, 4, 5, 6, 7, 8,
9
1, 3, 4, 5, 6, 7, 8, 9,
(2/10)^, (1/1)*
system.
Max
allowed
10*
8
10*
10
10
2