Table of Contents
Advertisement
1.
clamp slot on the power supply bay
3.
SAS connector
5.
storage controller card
Next steps
Install the integrated storage controller card.
Related Tasks
Removing the left expansion card riser
Removing the NDC riser
Installing the integrated storage controller card
Installing the integrated storage controller card
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: Ensure that the storage controller card is installed carefully, so that the components
on the card are not damaged.
Ensure that you follow the
Steps
1.
Reconnect the SAS data cables to the card.
NOTE: Ensure that you connect the cable according to the connector labels on the cable. The
cable does not function properly if reversed.
2.
Hold the card by its edges, and align the card edge connector with the connector on the system
board.
3.
Lower the card into the system until the card is firmly seated.
4.
Route the SAS data cable through the channel on the inner side of the chassis.
5.
Connect the SAS cables from the storage controller card to the connectors on hard drive backplane
or SAS expander card based on the hard drive configuration selected. For more information about
cabling images, see
6.
Close the clamp.
Next steps
1.
Install the NDC riser.
2.
If removed, install the left expansion card riser.
3.
Follow the procedure listed in
Related Tasks
Installing the NDC riser
Installing the left expansion card riser
108
Safety
instructions.
Removing the hard drive
After working inside your
2.
clamp
4.
storage controller card battery
6.
storage controller card connector on
the system board
backplane.
system.
Advertisement
Table of Contents
Troubleshooting
