Removing Memory Modules From The Memory Riser - Dell PowerEdge R930 Owner's Manual

CAUTION: Before installing the memory riser, ensure that the memory module socket ejectors
are in the locked position. Also ensure cables from the hard drive backplane are placed in the
cable latch and closed.
CAUTION: Use the memory riser handle, while installing and removing the memory risers.
Handling the memory riser without using the handle may cause injury.
1. Ensure that you follow the
2. If installed, remove the memory riser blank and the protective cap on the memory riser connector.
Steps
1. Hold the memory riser handle in the direction of the air flow, and align the memory riser with the
guides on the memory riser and fan cage.
2. Insert the memory riser into the guides on the memory riser and fan cage until it is fully seated in the
connector on the system board.
NOTE: If the memory riser is not seated properly, the memory riser handle will not get locked.
3. Press the memory riser handle until the handle lock clicks into place.
Next steps
Follow the procedure listed in

Removing memory modules from the memory riser

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you follow the
2. Follow the procedure listed in
3. Remove the memory riser.
WARNING: The memory modules are hot to touch for some time after the system has been
powered down. Allow the memory modules to cool before handling them. Handle the memory
modules by the card edges and avoid touching the components or metallic contacts on the
memory module.
CAUTION: To ensure proper system cooling, memory module blanks must be installed in any
memory socket that is not occupied. Remove memory module blanks only if you intend to install
memory modules in those sockets.
Steps
1. To open the memory riser, open the flip out brackets on the memory riser.
66
Safety instructions.
After working inside your
Safety instructions.
Before working inside your
system.
system.