Table of Contents
Advertisement
Remote Programming
You can use Remote Programming to access the Do-Not-Disturb (DND) and Call Forwarding
features from another system phone or an external phone.
Entering a Remote Programming Password
Before using Remote Programming, you should enter a new password.
To enter a Remote Programming password:
1.
2.
3.
4.
To change the station password from another phone, see
Using Remote Programming
To use Remote Programming:
1.
2.
3.
4.
Mitel
®
Single-Line Phone User Guide – Issue 13, September 2009
Lift the handset, and then dial 392.
Enter your current password (the default password is your extension number), followed
by #.
Enter the new password followed by #. You hear a confirmation tone.
Enter the new password again followed by #. You hear a confirmation tone.
Do one of the following:
•
Call your Direct Inward System Access (DISA) number (provided by your system
administrator). If necessary, enter your DISA password.
•
Use any phone on the system.
Dial 359.
Enter your extension number.
Enter your password followed by #. You can use Remote Programming to access any of
the following features:
To change the station password using Remote Programming:
a. Dial 392.
b. Enter the new password followed by #.
c. Enter the new password again followed by #.
To turn on DND:
a. Dial 370.
b. Enter the DND message number (01 to 20), and then enter the second-line message
text (if applicable).
To turn off DND:
Dial 371.
Call Features
"Using Remote Programming"
below.
Page 17
Advertisement
Table of Contents
