Table of Contents
Advertisement
Related Topics
Configuring Expansion Cards
Mounting the Gateway
The gateway can be mounted on a wall or DIN rail.
IMPORTANT: All mounting hardware is installer provided.
Mounting on a wall
The gateway can be mounted on a wall with six screws. The mounting holes in the base of the gateway
have a diameter of 4.3 mm. USRobotics recommends using screws with a minimum width of 4mm and a
minimum length of 30 mm (M4x30mm).
Tip: When choosing the mounting orientation of the unit, consider the direction of the cables and
antennas. Make sure cables are routed with sufficient ease to all connectors, and that the antennas
are unobstructed for easy positioning. The front panel LEDs should also be visible.
To wall mount the gateway:
1. Mark the six holes with a pencil on the wall.
2. Drill (if necessary) the holes in the mounting surface. Do not drill into the gateway housing.
here for a drawing of the mounting holes.
3. Mount the gateway with six M4x30mm screws
Revision: 1.00
Copyright 2015 U.S. Robotics Corporation
Click
18 |
P a g e
Advertisement
Table of Contents
