Table of Contents
Advertisement
Mode
This will define the state of the Ethernet interface when the WAN/LAN Switchover feature is
disabled.
When the WAN/LAN switchover feature is enabled the state of the Ethernet interface will be as
in the following table:
Result of WAN/LAN switchover feature
WAN
WAN
LAN
LAN
WAN/LAN Switchover
The WAN/LAN switchover feature defines the state of the Ethernet port after the gateway is
powered on. By default, WAN/LAN Switchover is enabled.
switchover
feature.
If set to Yes the gateway tries to connect to the Internet through the Ethernet connection, such
as an ADSL or cable modem. If a connection is unavailable, the port switches to LAN mode and
acts as a LAN interface.
Set to No to power on the Ethernet port as defined in the "mode" parameter.
MTU
The
MTU packet
IP address
Sets the IP address of the gateway. By default the IP address is 192.168.1.1. You can change this
to any value you want.
Netmask
Sets the netmask of the gateway. By default the netmask is set to 255.255.255.0. You can
change this to any value you want.
Enable DHCP server
Enables the DHCP server. By default the DHCP server is enabled. (When the Ethernet port is in
LAN state). In case you want to use static IP addresses in your network you can disable the DHCP
server.
DHCP range
Sets the DHCP range for the DHCP server.
Revision: 1.00
size: Value range 68 to 1500
Copyright 2015 U.S. Robotics Corporation
State of "Mode"
End result
LAN
WAN
WAN
WAN
LAN
LAN
WAN
WAN
Learn more about the WAN/LAN
25 |
P a g e
Advertisement
Table of Contents
