Table of Contents
Advertisement
4. Slide the card into slot, using the side channels or grooves on the housing to guide the card into
place. Make sure the screw holes line up.
5. Push gently until the card is flush with the housing.
6. Secure the card with the screws.
The following table lists the expansion cards available from Option and the slot.
Expansion Card
Wi-Fi Card (CG2101)
Low Cost Serial Card (CG1101)
Industrial Serial Card (CG1102)
Basic Ethernet Switch (CG1104)
PoE Ethernet Switch (CG1103)
Developers Card (CG1105)
Removing Expansion Cards
Note: The expansion card faceplate will deform if the card is pulled at the edge.
Do not attempt to remove the expansion card by pulling its edge!
1. Remove the Torx screws that fasten the card to the base unit.
2. Plug a connector into the mating connector on the expansion card. If the card has multiple
connectors, choose a connector near the right edge.
3. Remove the expansion card by pulling the plug or cable that is inserted into an expansion card
connector.
Revision: 1.00
Copyright 2015 U.S. Robotics Corporation
Slot
Back
Front
Front
Front
Front
Front
17 |
P a g e
Advertisement
Table of Contents
