US Robotics USR3520 User Manual page 54

NOTE: This is the same as pressing the hardware reset button on the back of the gateway for one
second.
Factory Reset
To reset the gateway to the factory default settings and overwrite all custom configuration changes:
1. Click Factory Reset to restart the device with the original firmware version from the factory.
2. Click Factory reset to confirm.
TIP: This is the same as pressing the hardware reset button on the back of the gateway for more than
five seconds.
Hardware Reset Button
The hardware reset button is located on the unit back panel. Using a pen or small screwdriver, press and
hold:

Hold for one second to perform a normal reset.

Hold for five seconds or more to perform a factory reset.
Revision: 1.00 Copyright 2015 U.S. Robotics Corporation 54 | P a g e