Table of Contents
Advertisement
Group 30 Electrical System
208
Plus d'informations sur : www.dbmoteurs.fr
NOTE! Install the positive (+) side brush and negative
(-) side brush as shown.
5. Install the rear bracket to the yoke by aligning the
matching marks. Secure the brush holders with
bolts, then tighten the through bolts.
6. Measure the end play of the armature. If the end
play exceeds the assembly standard, adjust it on
the rear side.
Armature end play, mm [in.]
Assembly Standard ... 0.3–0.7 [0.012–0.028]
7. Liberally coat the internal gear with grease, then
install the pinion shaft to the gear.
Advertisement
Table of Contents
