Table of Contents
Advertisement
Plus d'informations sur : www.dbmoteurs.fr
Reassembly
Reassembly is done in the reverse order of disas-
sembly.
Installing the front plate
1. Apply sealant to the front plate mounting surface
of the crankcase, then place the packing in posi-
tion. Apply the same sealant to the packing, then
install the front plate.
2. Replace the dowel pins if worn, or if the front
plate has been replaced.
3. Make sure that the lower end of the front plate is
flush with the bottom of the crankcase. Cut off the
excess of the packing neatly along the edge of
the plate.
Installing the idler shaft
1. Insert the idler shaft using the guide bolts.
2. Tighten the shaft mounting bolts to the specified
torque.
Installing the idler gear
1. Insert the idler gear into the shaft, and install the
thrust plate.
2. Install the thrust plate, then tighten the mounting
bolts to the specified torque.
Installing the oil pump and water pump
drive bearing cover
1. Insert the bearing cover into the front plate, then
tighten the cover mounting bolts to the specified
torque
Group 21 Engine Body
113
Advertisement
Table of Contents
