Plus d'informations sur : www.dbmoteurs.fr
Reassembly
Reassembly sequence:
NOTE! Replace all O-rings, unit seals and oil seals at
reassembly.
11
12
5
8
7
6
9
10
1. Use the oil seal installer to drive in the oil seal.
Apply engine oil to seal lip.
2. Use the unit seal installer to drive in the unit seal.
Replace the unit seal once disturbed.
NOTE! Install the unit seal after coating the outer ring
with sealant.
3. Press the impeller-side of the pump shaft, com-
plete with ball bearings, into the case. Install the
snap ring with its gap down.
4. Press in the unit seal ring with the unit seal float-
ing seat using the ring installer .
NOTE! Before installation coat the floating seat at two
locations with LLC solution (anti- freeze).
Group 26 Cooling System
4
3
2
1
191