Table of Contents
Advertisement
General information
How to Use This Manual
1. Parts in illustrations are numbered to correspond
with references to these numbers in text.
2. Items or conditions to be inspected during disas-
sembly are listed in the disassembled views.
3. Maintenance standards for inspection and repair
are described in text where relevant. For a quick
summary of maintenance standards refer to sec-
tion "Maintenance Standards" of this manual.
4. The sequence in which parts are to be reassem-
bled is summarized below each assembled view.
Such as:
5. Tightening torque under wet conditions is indicat-
ed as "(wet)" in text, drawings, and tables. When
so indicated, apply engine oil to the threaded por-
tion of the fastener. Unless indicated as (wet), the
tightening torque should be dry.
12
Plus d'informations sur : www.dbmoteurs.fr
Terms used in this manual
Before you read this manual, note that the following
special terms are used in dimensional and other
specifications.
Assembly standard
Indicates the dimension of a part, the dimension to be
attained at the time of reassembly or the standard
performance.
Norminal value
Indicates the standard dimension of a part.
Repair limit
A part which has reached this limit must be repaired.
Service limit
A part which has reached this limit must be replaced.
Standard clearance
Indicates the clearance to be obtained between mat-
ing parts at reassembly.
Advertisement
Table of Contents
